How to Adjust Your Nallu Sandals

What Properly Adjusted Sandals Look Like (Steps Below)

Your foot should be centered on the sandal.

The instep strap is looser (about a finger’s width).

The heel strap securely holds your foot in the center of the sandal.

Set it once, and then just slip them on comfortably.


Start:
Place your foot in the center of the sandal


Loosen the instep strap

Undo the knot and adjust the strap to fit comfortably, then retie the knot.

Check the fit, and repeat if needed.


Tighten the heel strap to hold your foot securely

If the strap is too loose, slide the buckle farther from the sole, about a finger’s distance.

Fine-tune the fit on your foot by tightening the strap, then secure it by closing the buckle.


Trim the strap and seal the end

Once you’ve perfected the fit, trim the strap at a 45-degree angle.

Leave a piece of the strap about two or three fingers long behind the buckle.


Pro Tips

Your foot expands under pressure, and a looser front strap helps compensate for that.

The WingLock wings flex and hold your foot, so the sandals will stay secure even if the instep strap is a bit loose.

When adjusting, make sure your foot stays centered on the sandal—don’t push it back, or the sandals won’t fit right.

Newly adjusted sandals will fully settle in after a few miles of walking. They’ll adapt to your foot, letting you enjoy their features to the fullest.